search:p mosfet開關相關網頁資料

- en.wikipedia.org
  
  MOSFET - Wikipedia, the free encyclopedia
  
  The metal–oxide–semiconductor field-effect transistor (MOSFET, MOS-FET, or MOS FET) is a type of transistor used for amplifying or switching electronic signals. Although the MOSFET is a four-terminal device with source (S), gate (G), drain (D), and body (
  
  2024-08-13
  
  瀏覽：1315
- www.ti.com
  
  P-Channel MOSFET Transistor | Products for P-Channel MOSFET Transistor
  
  Texas Instruments PMOS switches are P-channel enhancement-mode MOSFETs that are optimized for 3-V or 5-V power distribution in battery-powered systems. ... Products for P-Channel MOSFET Transistor ..
  
  2024-08-08
  
  瀏覽：425

p mosfet開關的相關文章

p mosfet開關的相關小型家用電器公司資訊

p mosfet開關的相關商品

switches - MOSFET as a switch? - Electrical Engineering Stack Exchange

日期：2024-08-11

In the picture shown, can "Output" be controlled to be 0V or 12V based on "Control"? Will be Drain and Source the way it is connected be a problem? ... You are using a P-channel MOSFET as a high side switch. That's fine. The direction you have it wired in...

全文

Power MOSFET - Wikipedia, the free encyclopedia

日期：2024-08-13

When in the OFF-state, the power MOSFET is equivalent to a PIN diode (constituted by the P + diffusion, the N − epitaxial layer and the N + substrate). When this highly non-symmetrical structure is reverse-biased, the space-charge region extends principal...

全文

Difference Between P Channel and N Channel on MOSFET | eHow

日期：2024-08-09

A MOSFET is a transistor that uses the effects of an electric field to control the flow of current; it acts as a switch and a signal amplifier. Unlike a junction transistor, which controls a large current with a smaller one, a MOSFET controls current with...

全文

integrated circuit - Help using MOSFET to switch on/off IC - Electrical Engineering Stack Exchange

日期：2024-08-10

Level shifting: You MAY be able to switch a 5V high side P channel MOSFET with a 3.3V mcu but the design would either be marginal or tricky. If you swing the drive signal 0/3.3V and have a 5V high side supply the FET sees 5V/1.7V relative to +5V. A MOSFET...

全文

Tact switch and mosfet transistor questions

日期：2024-08-12

Charlie, You can use a STD30PF03L. It comes in a DPAK or IPAK footprint. Your choice of physical size. See the P-Ch diagram in Reply #13 in this thread. Here are P-Ch Mosfets with lower internal resistance: FDD3706/FDU3706 (lowest resistance) and FDS6576...

全文

Intel's 22-nm process gives MOSFET switch a facelift | EE Times

日期：2024-08-07

The pursuit for the perfect switch faces many process challenges--a closer look inside Intel's latest 22-nm process. ... Consumer demand for higher performance and lower power has long been the driving force for CMOS technology. The continuous scaling of ...

全文